Gadgets and Gear 96-007 사용자 설명서

{카테고리_이름} Gadgets and Gear 96-007에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gadgets and Gear 96-007 2 페이지. Usb flash drive hidden camera
Gadgets and Gear 96-007에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

USB Flash Drive Hidden Camera Manual

Step 1:

Plug the USB into the USB port on your

computer. This device is compatible with

both PC and Mac operating systems.

plug here

A. Camera Lens

B. Microphone

C. USB

D. Micro SD Card Slot

E. On/Off Button

How to Charge Your Device

The light will glow blue while the device

is charging. When the device is fully

charged, the light will flash red.

lights will show here

USB Key

F. Camera/Photo Button

G. Indicator Light

H. Motion Detection Button

I. Cover

Step 2a:

How to Turn On/Off Your Device

Step 1: Press and hold the on/off button until the device

vibrates and the light glows purple.

Step 2: The device is now on and in standby mode and light

will glow red.

Step 3: To turn off the device, hold the on/off button until the

device vibrates and the red light blinks 3 times then turns off.

*Note: Press the camera/photo and on/off button at the

same time to reset it.

How to Record Video

Step 1: Once in standby mode (light will be glowing red)

press and hold the camera/photo button for 3 seconds.

Step 2: The device will then vibrate twice and the red light

will flash 3 times. After the third flash the camera will

begin recording immediately.

Step 3: To stop recording, press the camera/photo button once.

Step 4: The device will stop and save your current recording

and return to standby mode (light will be glowing red).

How to Take a Photo

Step 1: Once in standby mode (light will be glowing red)

press the camera/photo button once.

Step 2: The light will turn blue and the device will vibrate

once indicating the picture was taken.

Step 3: The light will then return to standby mode and the

light will glow red again.

How to Record Motion Detected Video

Step 1: Once in standby mode (light will be glowing red)

press the motion detection button once.

Step 2: The device will vibrate 3 times and the light will

flash purple 4 times.

Step 3: Now whenever there is movement in front of the

camera, it will automatically start recording.

Step 4: Press the motion detection button once again to

exit motion detection mode, and return to standby mode

(light will glow red again).

Step 2b:

If you have a USB wall charger, you can

charge the device in a wall outlet.

*Note: This product does not come with one.

lights will show here