gagalight RGB4000 사용자 설명서 - 페이지 11

{카테고리_이름} gagalight RGB4000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. gagalight RGB4000 18 페이지. Laser light

This product accepts digital control signals in protocol DMX512(1990).The

amount of lighting fixtures connected in parallel is no more than 32.Connect the

DMX controller's Output to the first lighting fixture's Input cable with a 2 core XLR

signal cable(Shown as above ),connect the first lighting fixture's Output cable to the

second lighting fixture's Input cable and connect the rest light fixtures in the same

way.Eventually,connect the last lighting fixture's Output cable to a DMXterminator

Under DMX-512 signal control mode,the last lighting fixture's DMX Output must be

connected with a DMX terminator.This prevents electrical noise from disturbing and

corrupting the DMX control signals.The DMX terminator is simply an XLR

connector with a 120Ω(ohm) resistor connected across pins 2 and 3,which is then

plugged into the output socket on the last projector in the chain.Then connections are

illustrated above.

ILDA control signal connection method:

Connection built through product male/female DB 25 degree socket.Like above

picture. In addition to the above connections, ILDA signal cannot be connected in any

other way

第 11 页