Gage Bilt GB206-500/25 사용 설명서 - 페이지 7

{카테고리_이름} Gage Bilt GB206-500/25에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB206-500/25 20 페이지.

When the tool is connected to a powerunit, operation is controlled by an actuator or switch attached to the hydraulic hoses. The

GB206-500/25A incorporates an air actuator to send a signal; the GB206-500/25 an electric actuator. When the button is depressed, a

directional valve in the powerunit directs oil to the front side of the piston forcing it and the nose assembly collet rearward. This action

causes the jaws to clamp on the fastener pintail and pull the sheets together. The anvil is forced over the collar, swaging it into locking

grooves of the fastener. Further force breaks the pintail off, approximately flush with the collar.

When the piston nears the end of its stroke it exposes flats on the back of the relief valve. These flats "dump" oil back to the powerunit

tank. When the button is released the directional valve reverses oil flow to the back of the piston and pushes the nose assembly off of

the swaged fastener. The spent pintail is released and drops out the back of the tool.

PULL Cycle

Piston Travel

PULL Pressure

GB206-500/25 / GB206-500/25A INSTALLATION TOOL

PRINCIPLE OF OPERATION

HYDRAULIC DIAGRAM

Relief

Valve

RETURN Pressure

Pressurized Oil

Unpressurized Oil

Images may not reflect actual tool

RETURN Cycle

Piston Travel

11/17 REV 4/23