Great Plains Industries, Inc. FM-530 Series 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Great Plains Industries, Inc. FM-530 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Plains Industries, Inc. FM-530 Series 8 페이지. Mechanical fuel meter

페이지 인쇄

Change Orientation

1. Remove the two Phillips head screws

which secure the cover to the cover-

plate assembly.

2. Remove the eight pairs of nuts and

bolts which hold the coverplate assem-

bly to the housing. (Figure 1) Note the

position of the reset button.

3. Rotate the coverplate assembly and

counter to the desired orientation.

Make sure the flow arrow in the

housing points toward the outlet port.

(Figure 2)

4. Make sure the housing O-ring is fully

seated and firmly tighten the eight nuts

and bolts which secure the coverplate

assembly.

5. Place the reset button in position. Secure

the cover to the coverplate assembly

with the two Phillips head screws.

Meter Installation

1. Remove protective plugs from the

meter inlet and outlet ports.

2. Wrap threaded male connections with

Teflon

tape or use a pipe sealant com-

pound compatible with petroleum

fuels. We recommend Lock-Tite thread

sealant at the inlet fitting in horizontal

orientation.

3. Install the meter on the pump using an

appropriately sized nipple. The meter's

flow path is marked on the housing

exterior with an arrow pointing toward

the outlet port.

4. Install other system components on the

meter and tighten snugly.

Figure 1

Before use, review the safety instructions

given above. Visually check the meter to

ensure it is securely connected to other sys-

tem components and there is no leakage.

Promptly wipe spilled fuel from the meter's

exterior and other system components.

The large meter display represents the

Batch Total for each fuel delivery. Before

dispensing, reset the Batch Total to zero

by pushing the reset button. (Figure 3)

Figure 2

The small display represents the Cumula-

tive Total of all fuel deliveries and cannot

be reset.

The meter is accurately calibrated at the

factory for use with diesel fuel. Due to dif-

ferences in viscosity and flowrates, the

meter may require recalibration to measure

other fuels or to adjust for inaccuracies.

1. Purge air from the meter and fuel sys-

tem by dispensing fuel into a container

until a full flow occurs. Close the

nozzle.

OPERATION

CALIBRATION

Figure 3