GREAT PLANES Micro Whizz 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES Micro Whizz에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Micro Whizz 16 페이지.

4. Locate and test fit the tail skid into the hole you drilled

earlier at the forward end of the slot in the bracket under the

horizontal stabilizer. When satisfied with the fit glue it into

place with CA.

Installing the Motor

1. Locate the brass gear and the small tube of green

adhesive. Test fit the gear onto the motor shaft. If you are finding

no problems with the fit, place a drop of the adhesive from the

small tube into the hole in the center of the gear. Before the glue

sets, position the gear on the shaft at a location where the end

of the motor shaft is flush with the end of the gear. Let the

adhesive cure for an hour before proceeding.

2. When the adhesive has cured completely, insert the

motor all the way into the gear drive unit. This is a tight fit

and you will also have to move the gear box back and forth

to allow the pinion gear to slide all the way into alignment.

3. Slide the motor/gear drive assembly into the nose of

the airplane. Mark the location of the mounting holes onto

the firewall. Remove the unit and drill 1/16" [1.5mm] holes at

the marked locations. Mount the assembly as shown above

with #2 x 3/8" [13mm] screws.

4. Install the collet, propeller adapter, and the propeller

as shown in the photograph above.

1. Install the three servos in the position shown in the

above photograph. Follow the directions included with your

particular servos for the proper mounting.