GREAT PLANES Seawind EP 사용 설명서 - 페이지 12

{카테고리_이름} GREAT PLANES Seawind EP에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Seawind EP 20 페이지.

페이지 인쇄

Apply the Decals

1. Use scissors or a sharp hobby knife to cut out the decals

close to the edges.

2. Refering to the photos on the box, place the decals on the

model where desired.

Set the Control Throws

If you have not already done so, use a Great Planes

™

AccuThrow

or a ruler to accurately measure and set the

control throw of each control surface as indicated in the

chart that follows. If your radio does not have dual rates, we

recommend setting the throws at the high rate setting.

Note: The throws are measured at the widest part of the

rudder (at the bottom).

These are the recommended high and low rate control

surface throws.

High Rate

ELEVATOR:

5/8" [16mm] up

5/8" [16mm] down

RUDDER:

1-1/4" [32mm] right 1" [25mm] right

1-1/4" [32mm] left

AILERONS:

7/16" [11mm] up

7/16" [11mm] down 1/4" [6mm] down

Low Rate

3/8" [10mm] up

3/8" [10mm] down

1" [25mm] left

1/4" [6mm] up

IMPORTANT: The Seawind has been extensively ﬂ own

and tested to arrive at the throws at which it ﬂ ies best.

Flying your model at these throws will provide you with

the greatest chance for successful ﬁ rst ﬂ ights. If, after you

have become accustomed to the way the Seawind ﬂ ies,

you would like to change the throws to suit your taste,

that is ﬁ ne. However, too much control throw could make

the model difﬁ cult to control, so remember, "more is not

always better."

Balance the Model (C.G.)

More than any other factor, the C.G. (balance point) can

have the greatest effect on how a model ﬂ ies, and may

determine whether or not your ﬁ rst ﬂ ight will be successful.

If you value this model and wish to enjoy it for many ﬂ ights,

DO NOT OVERLOOK THIS IMPORTANT PROCEDURE.

A model that is not properly balanced will be unstable and

possibly unﬂ yable.

At this stage the model should be in ready-to-ﬂ y condition

with all of the systems in place including the motor, propeller,

motor battery, ESC, and the complete radio system.

The Seawind comes with a unique balancing stand that

has the balance point built-in. All that needs to be done

is assemble the stand, place the model on the stand and

determine how much ballast will be required.

❏

1. Glue together the balance stand as shown. Glue the

3mm carbon tubes to the top of the stand.