AFG 7.1AT 빠른 조립 매뉴얼 - 페이지 2
{카테고리_이름} AFG 7.1AT에 대한 빠른 조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFG 7.1AT 5 페이지.
페이지 인쇄
TOOLS INCLUDED:
F 8 mm T-Wrench
F 5 mm T-Wrench
F 5 mm L-Wrench
F Screwdriver
PARTS INCLUDED:
F 1 Console Assembly
F 2 Console Masts
F 2 Console Mast Caps
F 1 Handlebar Assembly
F 1 Hardware Kit
F 1 Safety Key
F 1 Power Cord
F 1 Heart Rate Chest Strap
F 1 Audio Adapter Cable
F 1 Passport Box
NEED HELP?
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
ASSEMBLY STEP 1
HARDWARE fOR STEP 1 :
BOLT (A)
20 mm
Qty: 6
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Once the banding straps have been removed, do not transport this unit unless it is
fully assembled. Unpack and assemble the unit where it will be used. Never grab hold of
any portion of the incline frame and attempt to lift or move the treadmill. Lift the treadmill
from the roller end caps area while a second person removes the parts packed under
the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.
SPRING WASHER (B)
ARC WASHER (C)
8.2 mm
8.2 mm
Qty: 6
Qty: 6
LEAD WIRE
CONSOLE CABLE
Open hardware for step 1.
A
Pull lead wire through right console mast.
B
After pulling the lead wire through the mast, the
top of the console cable should be located at
the top of the mast. Detach and discard lead wire.
NOTE: Do not pinch console cable when placing
N
the mast onto the main frame bracket.
C
Attach console mast to main frame
bracket using 3 bolts (a), 3 spring
washers (b) and 3 arc washers (c).
NOTE: Do not tighten bolts until step 3 is complete.
D
Repeat step C on other side.
2