AFG M007 매뉴얼 - 페이지 15

{카테고리_이름} AFG M007에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFG M007 16 페이지. Changing table

Wall Safety Strap

• TOOLS NECESSARY: RUBBER MALLET, PHILLIPS SCREW DRIVER.

WARNING: WHEN UPRIGHT, IT IS POSSIBLE THAT THE FURNITURE MAY TIP OVER.

FOR YOUR CHILD'S SAFETY, PLEASE INSTALL THE SAFETY WALL STRAP BEHIND

THE FURNITURE.

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT AND KEEP

THESE INSTRUCTIONS FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, PLEASE

EMAIL US AT:

WWW.AFGBABYFURNITURE.COM

Safety Wall Strap 8" x 1.5" (1 pc)

Screw D4 x 3/4" (1 pc)

STEP 1: Make a mark near the top of the back

side of the furniture (in the center toward the top

frame of the furniture of where you would like to

install the safety wall strap). Insert the short screw

through the washer and through the safety wall

strap. Install the screw into where the mark was

made behind the furniture using a Phillips screw

driver

STEP 2: Locate a wall stud. With the back of the

furniture against the wall, locate the middle of the

top of the dresser and make a mark against the

wall. Measure 5cm down from the mark and drill a

1/8" pilot hole through the wall stud and into the

plaster wall.

CAUTION: The changer unit must be centered on

a wall stud as shown. If you are unsure of how to

locate the wall stud, contact a professional

contractor.

Washer (2 pcs)

Wall Stud (1 pc)

OR VISIT

Screw D4 x 1-3/8" (1 pc)