GAI-Tronics PHP400 설치 및 사용자 설명서 - 페이지 8

{카테고리_이름} GAI-Tronics PHP400에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics PHP400 20 페이지. Analogue version (1090/1099 series) with ampetronic hls-dm2 induction loop amplifier 230v ac power supply
GAI-Tronics PHP400에 대해서도 마찬가지입니다: 디자인 설치 및 사용 설명서 (20 페이지), 설치 및 사용자 설명서 (20 페이지)

페이지 인쇄

9. Before refitting the front case section, set up the GSM terminal as follows. Remove

the 2 screws holding the GSM terminal retaining bracket to allow access to the cover

and SIM holder.

10. Remove the cover from the GSM terminal to reveal the SIM card holder, fir the SIM

as shown below

11. Apply power (or replace the fuse). The LED on the internal power supply unit and the

right-hand green LED on the GSM terminal will illuminate.

The centre green indicator will show a rapid on/off flash while the GSM terminal

initialises itself (approx 15 secs).

12. Following initialization, the centre green indicator should be lit steadily – indicating

that the terminal is ready. The 3 LEDs on the GSM terminal can indicate various

different operating states and faults as shown below:

NOTE if the unit indicates that the SIM is locked (or blocked) this must be rectified

before the Help Point will operate. There is no way to unblock or unlock a SIM from

the Help Point.

PHP400 GSM Help Point.