ADEMCO 5850 설치 지침 - 페이지 3

{카테고리_이름} ADEMCO 5850에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO 5850 5 페이지. Glass break detector/transmitter

페이지 인쇄

INSTALLING THE BATTERY

Important Notes: • Use only UltraLife model U9VL-J 9-volt lithium battery.

1. Open the detector's cover door.

2. Check battery polarity orientation before installing.

Insert the battery into the battery holder with terminals

toward the ledge with embossed polarity markings.

3. Press the back end of the battery down until it is securely

seated in the holder. Close the cover door.

4. Wait at least 30 seconds to allow the detector to warm

up, then test the unit to ensure proper operation.

To remove the battery, pry up the back end of the battery

with a screwdriver (or similar tool) until it can easily be

removed.

NOTE: If a low battery message is displayed at the keypad and you suspect that the battery is not truly low, remove

the battery, wait at least 30 seconds, then reinstall the battery and re-test the transmitter.

ADJUSTING SENSITIVITY

1. With the detector in the approximate mounting location,

carefully open the cover door.

Forcefully opening and closing the door can cause the

detector to alarm. An alarm can also occur if the LED

ENABLE switch is moved too forcefully.

2. Slide the LED ENABLE switch in the direction of the

printed arrow (an orange tab will protrude from the

detector).

3. Using a screwdriver, adjust the sensitivity control fully

clockwise (maximum sensitivity).

4. Turn on all heating/air conditioning systems and other

equipment in the detector's vicinity.

Observe the yellow FLEX LED for about one minute.

5. Random LED flashing indicates the detector is sensitive to the subsonic sounds of operating equipment. Slowly

turn the sensitivity control counter-clockwise until the point at which the flashing stops.

6. After adjustment, close the cover door.

"LEARNING" THE TRANSMITTER ID

The 5850's serial number must be "learned" by the control before usage in the system. The control unit's installation

instructions provide detailed programming procedures for "learning" transmitter serial numbers. Before

programming, do the following:

1. Install the battery (if not already installed). Observe polarity!

2. Remove the cover assembly (see step 3 of Mounting section).

3. When programming this transmitter, note the following:

• Input Type = 3 (Supervised RF)

• Loop Number = 1

To fault the detector when prompted, momentarily press the test switch located on the exposed transmitter PC

board. The keypad will beep to confirm the signal. Wait 3-6 seconds before pressing the second time.

4. Test the detector after "learning" into the system. Refer to the Testing Alarm Operation section.

www.PDF-Zoo.com

• Observe polarity.

• When replacing the battery, wait at least 30 seconds after removing the old battery, before

installing the new one.

LED ENABLE

SWITCH

Remove this screw

to remove cover

--- 2 ---

TAMPER SWITCH

–

Install

Battery

Here

BATTERY

(NOTE POLARITY)

SENSITIVITY

CONTROL

ALARM LED

LATCH SWITCH

LEDs

–

TAMP.