AutomationDirect IRONHORSE GSD3 Series 사용자 설명서 - 페이지 8
{카테고리_이름} AutomationDirect IRONHORSE GSD3 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AutomationDirect IRONHORSE GSD3 Series 12 페이지.
페이지 인쇄Trim Pot Adjustments
Before the power is applied, the speed potentiometer and trim pots should be preset as follows:
TRIM POT PRESET
1) Preset trim pots in the counter-clockwise position (CCW).
2) Apply power and set GSD3-24x-3N4 power ON/OFF switches to the ON position.
3) Turn the Speed pot fully CW.
4) Adjust the MAX trim pot in the CW direction until the maximum desired speed is obtained.
5) Turn the Speed pot fully CCW.
6) Adjust the MIN trim pot in the CW direction until deadband or the desired speed is obtained.
TRIM POT ADJUSTMENT
The IR COMP trim pot is used as a regulation adjustment. If better motor regulation is needed between
minimum and maximum loads, then adjust the IR COMP trim pot as follows:
1) Turn the Speed pot CW to the 50% position.
2) Turn the IR COMP trim pot CW as needed to increase regulation.
3) Recheck and readjust the trim pots if necessary. Trim pot interaction with each other will be minimal.
Page 8
IronHorse GSD3 DC Drives User Manual – 1st Ed, Rev C – 10/15/2019