ADEMCO 5879 설치 및 설정 매뉴얼 - 페이지 2
{카테고리_이름} ADEMCO 5879에 대한 설치 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO 5879 3 페이지. Holdup switch / transmitter
페이지 인쇄MOUNTING
HOLE
COVER
SCREW (2)
No. 6x1/2
MOUNTING
SCREW (2)
No. 6X2
THIS DEVICE MUST BE PERMANENTLY
MOUNTED WITH THE SCREWS SUPPLIED.
HOLDUP SWITCH SHOWN MOUNTED
IN TYPICAL UNDER COUNTER APPLICATION.
Figure 2. Typical Holdup Switch Installation
Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are
vital to continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to
the user, as well as acquainting the user with the proper operation and limitations of the alarm system and its
component parts. Recommendations must be included for a specific program of frequent testing (at least
weekly) to insure the system's operation at all times.
This device complies with Part 15 of the FCC Rules.
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
BREAKAWAY
TAMPER
SCREW
No. 6X3/4
MOUNTING
COVER
SCREW (2)
No. 6x1/2
IMPORTANT:
FCC ID: CFS8DL5869-1
CANADA: 573F-58691
SPECIFICATIONS
Physical
Battery
Frequency
Reset Key:
MOUNTING
HOLE
Agency:
SCREW (2)
No. 6X2
5869-004-V0
TO THE INSTALLER
2
1-15/16"W x 5-15/16"H x 1-3/16"D
(50mm x 150mm x 30mm)
3-volt Lithium. ADEMCO 466, Duracell
DL123A, Panasonic CR123A, Sanyo CR123A,
Varta CR123A, or equivalent.
345MHz
Supplied, Part Number K4563 to order
separately
UL 636 – Holdup alarm units and systems
C
US
R
LISTED
Operation is subject to the