dB Technologies sub 618 빠른 시작 사용 설명서 - 페이지 3

{카테고리_이름} dB Technologies sub 618에 대한 빠른 시작 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dB Technologies sub 618 4 페이지.

3) Connections and controls

All the connections and controls are in the amplifier

panel side:

SUB 618

www.dbtechnologies.com

1 – Balanced XLR inputs

2 – Balanced XLR outputs

3 – Subwoofer level rotary

4 – Outputs Mode (Link or Xover mode)

5 – Subwoofer Setup (Polarity switch) and

Subwoofer Mode button (Flat/Boosted)

6 – LEDs (Limiter, Signal / ON)

7 – Mains input connector

8–Power switch (ON, OFF)

a) Once you have properly set up the desired

configuration (see also the complete user manual and

accessories instructions for further information),

connect the audio input (mono) or inputs (stereo) (1).

Connect the output (mono) or outputs (stereo) (2) and

consequently set the Subwoofer level to 0 dB in the

right position (3).

b) Set properly the Outputs Mode (4), ("Link" in case of

direct link connection, "Xover" in case of 120 Hz

crossover, for example when in use with a OPERA or B-

HYPE series model).

c) Choose the Subwoofer Polarity (Normal or Reverse)

(5) to obtain the proper behavior. It is possible to add

a low-frequencies boost (5) with the related Subwoofer

Mode switch.

d) Connect the VDE cable to the related connector (7).

Then turn ON the power switch (8). The, the

"Signal/ON" LED (6) turns on, signaling the proper

power connection, and starts blinking at the presence

of audio signal (greater than -20 dBu).

Check the site

information, for added accessories and for the

complete user manual!

www.dbtechnologies.com

Rev 1.1 cod. 420120252Q

for further