ADEMCO VISTA-20SE 사용자 설명서 - 페이지 2

{카테고리_이름} ADEMCO VISTA-20SE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO VISTA-20SE 4 페이지. 2-partitioned security system
ADEMCO VISTA-20SE에 대해서도 마찬가지입니다: 프로그래밍 양식 (8 페이지), 사용자 설명서 (9 페이지), 프로그래밍 양식 (8 페이지)

페이지 인쇄
ADEMCO VISTA-20SE 사용자 설명서
Locating Control Panel Box
The battery control panel box is typically located inside a closet, garage or attic. Please note: the control box is different
from the panel keypad that is used to arm and disarm the security system.
Install New Battery
1. Put System on Test
Once you have received the replacement battery, put the system on test.
2. Locate & Open Control Panel Box
Open the control panel box, usually located in a closet, by removing the screws on the side and bottom of the cover, or
with the panel control box key.
3. Examine the Old Battery
If the battery looks normal, proceed to step 4. If it looks abnormal (i.e., has a swollen or split case, liquid is leaking from
the case, the case is hot to the touch, the terminals are corroded), schedule service by calling 800.238.2727 and remove
your system from test.
4. Disconnect the Battery
Please read the Battery Safety Tips below to ensure your complete this process safely.
1. Pull the black wire's connector from the negative (-) battery terminal. This may require pliers with electrically
insulated handles. The connector may need to be wiggled slightly for it to loosen and disconnect.
2. Repeat the process to remove the red wire's connector from the positive (+) battery terminal.
3. Remove the old battery from the control panel box. Do not touch any metal objects to the terminals on the
battery or to the open end of the black and red wire connectors.