DBI SALA ULTRA-LOK 3504552C 사용 설명서 - 페이지 11

{카테고리_이름} DBI SALA ULTRA-LOK 3504552C에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DBI SALA ULTRA-LOK 3504552C 16 페이지. Self-retracting devices

페이지 인쇄

4.8

RETRIEVAL DISENGAGEMENT: To disengage Retrieval mode:

CAUTION: When Retrieval mode is disengaged, any extended Lifeline will retract into the SRL. To avoid

possible injury, retract the Lifeline prior to disengagement or hold onto the Lifeline.

1. Remove any load from the Lifeline.

2. Pull and hold the Shift Knob in the unlocked position.

3. Pull the Crank Arm out to disengage and then release the Shift Knob.

4. Pull out and rotate the Retrieval Handle down toward the SRL Body to stowed position.

5.0 INSPECTION

5.1

i-Safe™ RFID TAG: The Self-Retracting Lanyard includes

an i-Safe™ Radio Frequency Identiﬁ cation (RFID) tag. The

RFID tag can be used in conjunction with the i-Safe handheld

reading device and web based portal to simplify inspection and

inventory control and provide records for your fall protection

equipment. For details, contact a Capital Safety Customer

Service representative (see back cover); or if you have already

registered, go to http://isafe3.capitalsafety.com/Pro/. Follow

the instructions provided with your i-Safe handheld reader, or

on the web portal, to transfer your data to your web log.

5.2

INSPECTION FREQUENCY: The Ultra-Lok Self-Retracting Lanyard must be inspected at the intervals

deﬁ ned in Section 2.2 - Inspection Frequency". Inspection procedures are described in the "Inspection

Checklist" (Table 2).

IMPORTANT: If the Self-Retracting Lanyard has been subjected to fall arrest or impact forces it must be

immediately removed from service and sent to an authorized service center for repair.

IMPORTANT: Extreme working conditions (harsh environments, prolonged use, etc.) may require

increasing the frequency of inspections.

5.3

UNSAFE OR DEFECTIVE CONDITIONS: If inspection reveals an unsafe defective condition, remove the

Self-Retracting Lanyard from service immediately, mark as "UNUSABLE", and send to an authorized service

center for repair.

NOTE: Only Capital Safety or parties authorized in writing may make repairs to this equipment.

5.4

PRODUCT LIFE: The functional life of DBI-SALA Self-Retracting Lanyards is determined by work conditions

and maintenance. As long as the product passes inspection criteria, it may remain in service.

6.0 MAINTENANCE, SERVICING, AND STORAGE

6.1

CLEANING: Cleaning procedures for the Self-Retracting Lanyard are as follows:

•

Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so

excess water can drain out. Clean labels as required.

•

Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with

heat. An excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the

housing causing a potential free fall hazard. Replace lifeline if excessive buildup is present.

6.2

SERVICE: Additional maintenance and servicing procedures must be completed by an authorized service

center. Do not attempt to disassemble the SRL or lubricate any parts.

6.3

STORAGE AND TRANSPORT: Store and transport Self-Retracting Lanyard in a cool, dry, clean environment

out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRL after any

period of extended storage.

Figure 12 – i-Safe RFID Tag