Celiera KFR-51GW/Ga 사용자 설명서 - 페이지 13
{카테고리_이름} Celiera KFR-51GW/Ga에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celiera KFR-51GW/Ga 14 페이지. Split wall-mounted air conditioner
페이지 인쇄[We hope
you
will
know
the
following when
using the unit]
The unit can not be restarted just after shut down .
( RUN lamp is illuminating )
/"
"^
(f>'j ^^^^^
<
Not operate '
Air is not blown out at starting of heating operation.
Air is not blown out for 6 to 12 min , at heating operation .
Air is not blown out at DRY operation .
Mist is blown out at COOL operation .
Odor is sent out .
Noise is heard cracking sound .
^^^
m
Noise is heard cracking sound .After a power stoppage or after
disconnecting the power supply plug.
Operation can not be restarted even if the power is recovered.
Remote control signals are not received .
Moisture may form on the air outlet grilles .
V
Restart is stopped for 3 minutes after shut down to protect
\
the unit .
jflh
f Please wait for"
1
,
pW^i
i 3 minutes .
j
\y
J
Three-minute protection timer incorporated in the microcomputer actuates
automatically . Except that power is connected , this function does not
actuate .
Air blow is stopped to prevent blowing out of cold air
until the indoor heat exchanger is warmed .( 2 to 5 min )
( HOT KEEP)
When outdoor temperature is low and humidity is high , the unit
sometimes performs defrosting automatically . Please wait . During
defrosting , water or steam are raising from the outdoor unit .
Indoor fan is sometimes stopped to prevent vapor of dehumidified
moisture and save energy .
This phenomenon sometimes occurs when the temperature and
humidity of the room are very high , but it will disappear with the
lowering of the temperature and humidity .
Air blown out during operation may smell . This is the smell
of tobacco or cosmetics slicked to the unit .
This is caused by the refrigerant that is circulating inside the unit.
This is caused by heat expansion or contraction of plastics.
The memory circuit of the microcomputer is cleared. Operate
the remote controller again to restart the operation .
Remote control signals may not be received when signal receiver
on the air conditioner body is exposed to direct sunlight or strong
lighting . In that case , interrupt the sunlight or darken the lighting.
If the unit is operated for a long period of time with the high
humidity , moisture may form on the air outlet grilles and drip
down .