Autonics BD-030 매뉴얼 - 페이지 3
{카테고리_이름} Autonics BD-030에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics BD-030 14 페이지. Laser displacement sensors
Autonics BD-030에 대해서도 마찬가지입니다: 제품 설명서 (6 페이지), 제품 설명서 (5 페이지)
페이지 인쇄
BD Series
Specifications
Amplifier unit
Model
Power supply
Power consumption
※1
Timing
Output reset
Control input
Laser OFF
※ 2
Zero adjustment
Bank change
Judgment output (HIGH/GO/LOW)
Alarm output
Voltage
Analog output
※3
Current
Residual voltage
Protection circuit
Response time
Min. display unit
Display method
Display range
※4
Display period
Insulation resistance
Noise immunity
Dielectric strength
Vibration
Shock
Ambient
temperature
Environment
Ambient
humidity
Protection structure
Material
Connection
Sensor head compatibility
Accessory
Approval
Weight
※5
※1: Power to the load is not included.
※2: Use after assigning to external input line. For the details, refer to the item in '▣ Parameter group'.
※3: It is possible to use among -5-5V, 0-5V, 1-5V, 4-20mA by parameter setting.
※4: Setting range is assigned automatically when connecting sensor head.
※5: The weight is with packaging and the weight in parenthesis is only unit weight.
※The temperature or humidity mentioned in Environment indicates a non freezing or condensation environment.
E-8
BD-A1
10-30VDCᜡ ±10% (When connecting BD-C Series communication converter, 12-30VDCᜡ)
Max. 2800mW (30VDCᜡ)
No-voltage input
NPN or PNP open collector output (Load current: Max. 100mA)
NPN or PNP open collector output (Load current: Max. 100mA)
-5-5V, 0-5V, 1-5V (Resistance: 100Ω, ± 0.05% F.S., at 10V)
4-20mA (Max load resistance: 350Ω, ± 0.2% F.S., at 16mA)
NPN: Max. 1.5V, PNP: Max. 2.5V
Reverse polarity protection circuit, output overcurrent (short-circuit) protection circuit
0.33, 0.5, 1, 2, 5 ms (5-step adjustment)
1㎛
Dual display by 6-digit, 11-segment LED
±99.999mm to ±99mm (4-step adjustment)
Approx. 100ms
Over 20MΩ (at 500VDCᜡ megger)
Square shaped noise by noise simulator (pulse width: 1㎲) ±500V
1,000VAC 50/60Hz for 1 minute
1.5mm amplitude at frequency of 10 to 55Hz (for 1 min) in each X, Y, Z direction for 2 hours
300m/s2 (Approx. 30G) in each X, Y, Z direction for 3 times
-10 to 50℃, storage: -15 to 60℃
Under 85%RH, Storage: under 85%RH
IP40 (IEC Standards)
Case: Polycarbonate, Cover: Polycarbonate, Cable: Polyvinyl chloride
Connector type
BD Series sensor head: 1
Mounting bracket, Side connector
Approx. 228g (approx. 126g)