Autonics BS5-P Series 매뉴얼 - 페이지 3
{카테고리_이름} Autonics BS5-P Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics BS5-P Series 4 페이지. Push button type photomicro sensors
Autonics BS5-P Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지)
페이지 인쇄
BS5-P Series
Dimensions
4-R3
6.5
Ø8
3
6-R3
Installation
When installing the product, tighten the screw with a tightening torque of 0.59N·m.
Do not pull the cable with a tensile strength of 30N or over. It may result in fire due to the broken wire.
1) Installation on non-flush surface
Install the sensor after fitting the sensor in the opening as shown in the figure below.
2) Installation on flush surface
Insert a spacer between the installation surface and the mounting surface of the sensor as shown in the figure below.
A-138
Operation indicator (red)
2-Ø3.2
21.3
3.7
25
Operation indicator (red)
18
Installation surface
Spacer
Installation
surface
Ø3, 1m
D
d
※ Recommended size
D: 6mm
L
d: 3.3mm
L: 4±0.1mm
(unit: mm)