AGRO ELECTRO 0237 사용자 설명서 - 페이지 5

{카테고리_이름} AGRO ELECTRO 0237에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGRO ELECTRO 0237 20 페이지.

페이지 인쇄

quality of the all other components of the fence. For grounding, use

a galvanized metal rod with a length of at least 1 m (attention it is not

included in the package), which has to be driven into the ground at

least 1 m deep. An M12 threaded metal rod is ideal for this purpose,

as the ground cable

can be easily connected to this.

In the case of long electric fences (over a few kilometers), or if the

soil is mostly dry, create several interconnected grounds, located

a few meters away of each other, to improve the efficiency of the

electric fence.

Under no circumstances connect the ground of the system to an

existing grounding – for example to the ground of the 230 V mains.

You must create a separate grounding in the immediate vicinity of

the system.

The accumulator

Use a 12 V accumulator (lead-acid or gel) to store the energy

Attention, the accumulator is not included in the package! Do not use

other types of accumulators, such as Ni-MH or Li-ion!

Use an accumulator having a capacity of at least 45 Ah. The maximum

capacity is determined by the size that fits in the metal box.

The accumulator should be connected by the clamps

• Red clamp = positive ( � ) pole of the accumulator.

• Black clamp = negative ( � ) pole of the accumulator.

Starting the system

Before all, check the position of the on/off

OFF position.

In the first step connect the accumulator by the clamps

and

. Caution: do not allow the power cords to touch the high

voltage output � of the electric fence energizer

circumstances!

In the second step, check the lights on the charge controller to deter-

mine the correct operation of the system (study the chapter named

"The charge controller" below). Both LED lamps

continuously green.

In the last step start the electric fence energizer by moving the

switch to the ON position.

The operation of the device can be tracked by sound: you should hear

electric discharge sounds approximately every second.

Stopping the system

To turn off the energizer device, move the switch

To turn off the system completely, it is not enough to move the switch

ates electricity, which leaves in operation all the electronic circuits

inside the box.

To move or store the system, follow the steps below:

• Make sure the switch

• Cover the solar panel with a light-blocking material (cardboard,

black nylon bag) to stop generating electricity.

• Disconnect the accumulator, then remove it from the metal box to

prevent breaking the electronic circuits and the corrosion caused

by acid leakage from the accumulator.

The charge controller

and

The charge controller ensures the stabilization of the variable voltage

produced by the solar panel, protects against reverse polarity and

controls the correct charging of the accumulator.

The controller has two important LED indicator

important information regarding the state of the accumulator:

switch. It has to be in

Charging indicator

• Off – No charging.

• Continuous green – Charging.

• Slow flashing green — Maintaining the charged state of the

under any

accumulator.

• Fast flashing green — Maintenance mode of the accumulator (buck

charge, desulfation).

and

must be

to the OFF position, because the solar panel continuously gener-

is in OFF position.

Normally this light has to be continuously green.

to the OFF position.

and

which show