AGRO ELECTRO 0202 사용자 설명서 - 페이지 6

{카테고리_이름} AGRO ELECTRO 0202에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGRO ELECTRO 0202 20 페이지. Solar panel with charge controller

페이지 인쇄

Work modes

The controller can have multiple work modes. These modes are

detailed in the table below. Attention, the work modes are related

exclusively to the

output (

accumulator charging process.

To enter the work mode changing menu, press and hold the

for 3 seconds. After entering the menu, every repeated press of the

button switches to the next mode. After reaching the end of the

possibilities, the first mode comes again. If the button is not touched

for a while, the controller memorizes the selected mode and exits

the menu.

ATTENTION:

our

the

output due to the following reasons:

• It becomes highly possible to damage the connected

consumers due to over-voltage, by an accidental disconnec-

tion of the accumulator.

• The accumulator may deplete accidentally due to a wrong

work mode selected.

• It is highly possible to damage the

overload or short circuit. Although the output is protected for

these situations, the protection is limited for certain situa-

tions and it is not guaranteed to always work as expected.

In the case when you decide to use the

enlists the possible work modes. But, by using the

company refuses to offer the 1 year warranty for this device, due

to the extremely high possibility to damage the controller!

and

), and do not affect at all the

company

does

not

recommend

output due to an

output, the table below

Display Work mode

Only charge.

button

Automatic

...

illumination

mode with

using

delays of hours.

Please pay

attention to

the dot on the

display!

Automatic

lighting with

a delay of

10 seconds.

The

output, our

always active.

Manual mode

( = Hand).

Test mode

( = debug).

Description

In this mode the

output of the controller

is disabled, but the charging control is still

working (as in any other mode).

The controller is being sold set in

this mode.

We recommend using the controller

exclusively in this mode!

In this mode the controller activates the

output when the environment light

decreases (to turn on the lights), after

a 1...13 hour delay.

means a delay of one hour,

hours,

nine hours,

and the last value,

In this mode the controller activates the

output when the environment light

decreases, after a delay of 10 seconds.

When the environment light gradually

increases, the output is turned off after

a delay of 10 seconds.

output is

The

output is always activated (except

when the charge level of the accumulator

is low).

The

output's activated state alternatively

changes on each press of the

(after the controller returns from the work

mode menu).

It is the same as the

are no delays before changing output state.

means two

(zero+dot) 10 hours,

(three+dot) 13 hours.

button

mode, except there