Autonics LSE-4A5R2 제품 설명서 - 페이지 5

{카테고리_이름} Autonics LSE-4A5R2에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics LSE-4A5R2 5 페이지. 2d laser scanners
Autonics LSE-4A5R2에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)

페이지 인쇄

Checking SV

> 9 > Keys for entering each function

The setting value can be checked through the remote controller and the indicator on

the laser scanner for each function.

Theindicator flashes as much as the value of the numeric keys. For more detailed

setting value, refer to Function Setting: Remote Control.

Function

Entering Key

Sensor position

Pos.

Activated channel (s)

01)

Monitoring zone

W or H > 0 > Ch No.

02)

Concentrated

W or H > 1 > Ch No.

monitoring zone

Sensitivity level

Level

Minimum size of the

Size

scanning target

Monitoring time

Time

Output

RST > 4

01) Activated Ch1, Ch3 and not activated Ch2, Ch4

(flash once) >

(flash twice) >

02) When checking the height after setting as W 3.4 × H 4.9 m

(flash 4 times) >

Troubleshooting

Check the normal operation status of laser scanner periodically.

Error

Causes

Supply the power voltage.

Power indicator

Wrong polarity connection of power

(

, green) OFF

supply

Voltage error

Error indicator

(

, orange)

Temperature error

flashing

Inside error

Detection by external environment

(snow, rain, or hail, etc.)

Relay output

There is the equipment which

is ON without

generates strong magnetic force

objects within

or high frequency noise (motor,

teaching area

generator, or power cable, etc.) near

the laser scanner.

Laser scanner

The batteries' life cycle of the

does not react

remote control is over.

for remote

Wrong direction control of the

control

remote control

operation.

After pressing

the

key of

Password incorrect.

remote control,

the setting is

not available.

LAN connector connection error

atLidar (PC

program)

IP address is not same.

and the laser

scanner does

IP address of the laser scanner and

not connected.

wireless router is same.

Indicator

(flash)

Channels'

(flash)

Between Ch

(flash once)

Integer value

(flash)

Decimal point

(flash once)

Decimal value

(flash)

Channels'

(flash)

(flash once)

(flash once) >

(flash 9 times)

Troubleshooting

Check the rated power supply.

Check the Connection diagram when

wiring the unit.

Use the unit within the rated voltage.

Use the unit within the specified

ambient temperature.

Contact the seller.

Change the settings: sensitivity level,

scanning target size, monitoring time.

Install the laser scanner away from the

equipment which generates strong

magnetic force or high frequency

noise.

Change the batteries.

Operate the remote control towards

the near laser scanner.

Turn OFF the power and re-supply the

power, the password is available to

reset.

Contact the seller.

Check the PC and LAN connector

connection part.

Check the IP address of the laser

scanner and the user PC.

Set the wireless network (Wifi) to

"Disable" in the network settings of the

Windows operating system.

18, Bansong-ro 513Beon-gil, Haeundae-gu, Busan, Republic of Korea, 48002