iHealth BP7 소유자 매뉴얼 - 페이지 6

{카테고리_이름} iHealth BP7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. iHealth BP7 16 페이지. Wrist
iHealth BP7에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (4 페이지)

a. Be seated with your feet flat on the floor without crossing your legs.

b. Place your hand palm-side up in front of you on a flat surface such as a desk or table.

c. The middle of the cuff should be at the level of the right atrium of your heart.

Note: Blood pressure can be affected by the position of the cuff and your

physiologic condition.

During measurement, press the "START/STOP" button for 2 seconds to turn off the monitor

manually.

Monitor Status

Waiting to connect

Measuring

Measurement completed

Operation Instructions With iOS Device

Before measurement begins, adjust the height of your wrist until it is level with the right atrium of

your heart. The App will detect your wrist position and the measurement will begin automatically

when the correct position is detected,. If not positioned correctly, the measurement will not start.

Do not move and maintain a steady position until the measurement is completed.

During measurement, press the "START/STOP" button to stop measurement, Press the

START/STOP" button for 2 seconds to turn off the monitor manually.

For detailed operating instructions, please visit http://www.ihealthlabs.com.

Note: Please consult a healthcare professional for interpretation of blood pressure measurements.

Measuring without an iOS Device

Offline measurement is enabled automatically at your first online measurement. To start offline

measurement when disconnected from the iOS device, turn on the monitor by pressing the

START/STOP button. The status indicator light will be green and the monitor will begin

measurement. If measured successfully, the measurement will be stored in the iHealth Wireless

Blood Pressure Wrist Monitor and the status indicator light will flash green. The reading is not

visible until the next iOS connection. The measurement will be uploaded to the device

automatically upon the next iOS connection. Otherwise the status indicator will be red for a

moment then change to flashing green. The monitor will turn off automatically after 2 minutes of

non-operation. Alternatively, you can keep on pressing the "START/STOP" button for 2 seconds to

turn off the monitor manually.

During measurement, press the "START/STOP" button to stop the measurement process.

Important: Please consult a healthcare professional for interpretation of blood pressure

measurements

Bluetooth Indicator

Flashing blue light

Steady blue light

Gradually extinguishing light