Autonnic A5023 사용자 및 설치 설명서 - 페이지 6

{카테고리_이름} Autonnic A5023에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonnic A5023 19 페이지. Fluxgate compass

When the A5023-24 is viewed from the front face with the LED facing, then

Switch 1 is on the right and Switch 2 is on the left.

Switch 1:

Switch 2:

must be mounted upright but at any azimuth. Pressing S2 sets the

heading to zero and so can be done when the whole installation is

headed North.

Both together

the auto-calibration process to halt and restores the previously saved

calibration values.

1.4

Indicator light

A blue light indicates three states of the A5023-24.

State 1

State 2

State 3

After the reset command,

uncalibrated and will have a long flash.

Note that the LED can be turned off and on by the DLED command – see section

Start the auto-calibration process

Set reference NORTH heading. The A5024/4

Pressing both together for at least one second causes

Uncalibrated

In the process of calibration continuous

Calibrated

$PATC,IIHDG,0CV<CR><LF>

long flash

short flash

6 of 19

A5023/24

, the compass is