Autopilot APCG4NG 매뉴얼 - 페이지 9

{카테고리_이름} Autopilot APCG4NG에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopilot APCG4NG 13 페이지. 4 burner co2 generator (lp or ng)

Page 8

APCG4

Electronic Ignition Control Module

, the

For safer operation

APCG4 has an Electronic Ignition

Control Module that eliminates the "open" pilot flame. The

module creates a spark that lights the burner(s), providing

consistent and controlled starts.

The dual redundant solenoid valves are controlled by the

ignition controller. This provides twice the safety as a single

solenoid CO2 generator.

There are 4 LED indicators located on the side of the

generator near the power switch.

Main Power On - When lit, indicates the 24 volt power supply

is connected or power is on.

Lock Out (error) - When flashing this indicates that the ignition

controller shut off the solenoid valve(s) and the unit is locked

out or will not operate until power has been cycled OFF then

back ON.

Main Valve On – When lit, indicates the ignition controller has

activated the main solenoid and the unit is in operation.

Pilot Valve On – When power is applied, the electronic ignition

module will begin to provide a spark for 15 seconds while the

"pilot" solenoid is energized. The indicator will remain lit while

the solenoid is activated and should be lit during operation.