Autopot 80 Pot System 설정 매뉴얼 - 페이지 2
{카테고리_이름} Autopot 80 Pot System에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopot 80 Pot System 2 페이지. 800l tank minimum
Autopot 80 Pot System에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지)
페이지 인쇄
80Pot system contents
• 2 x 400 ltr FlexiTank or
• 40x 16mm-6mm Cross Connector
rigid green 350 ltr tank
• 80x Tray & Lid
• 2 x 16mm Click-fit tank adaptor
• 80x 15ltr Pot
& filter
• 80x AQUAvalve
• 1x 30 metres of 16mm pipe
• 1x 40 metres of 6mm pipe
• 4x 16mm In-line tap
• 80x Marix Discs
• 2x 16mm Cross Connector
• 80x Root Control Discs
Suggested layout
400 ltr
FlexiTank
400 ltr
FlexiTank
Minimum
height of tank
150mm
6mm pipe
16mm In-line tap
16mm pipe
16mm Cross Connector
16 - 6mm cross connector
AQUAvalve
• P ot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10
days before turning your system on. This will encourage a stronger and healthier root system.
• A lways raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
• F or best results, we recommend mineral fertiliser. Do not use organic fertilisers, as they have a tendency to
block small pipe work.
• C lean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
• A lways use free draining substrates, for example: soil perlite, coco perlite, soil/clay pebbles, coco/clay
pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
Maximum distance 20 metres
16mm Click-fit tank adaptor & filter
Advice
1Pot module dimensions
350mm
1
Put black marix
disc in pot
3
Remove collar
Push 6mm pipe through
collar and attached to
AQUAvalve nozzle
Rescrew collar - DON'T
overturn... when you
feel it grip STOP
5
Position tray
so it is level
Insert root control
disc Gold face up
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
1Pot module
setup
instructions
400 ltr
tank
680mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
Connect AQUAvalve
so 'half moon' is on
T section in the tray
6
Cut 6mm pipe to
appropriate length
8
Place
pot
in
the
tray, make sure it is
CLEAN!
Place lid over valve
onto tray