Galvin Safe-Cell 50101C 제품 설치 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Safe-Cell 50101C에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Safe-Cell 50101C 4 페이지. Manual prison tapware

PRE-INSTALLATION -

−

If the mounting holes do not already exist, mark out

and drill the hole in the bench/trough to suit your

requirements.

Note: Before installation, all lines must be flushed.

We recommend that a line strainer be installed

prior to drinking taps to eliminate any foreign material.

Ezy-Grip

INSTALLATION

INSTALLATION COMPLIANCE: Galvin Specialised products must be installed in accordance with these

installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.

Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of the

product.

IMPORTANT: Whilst our product designs take into account a broad range of installation types and surfaces, it is

important that surfaces which fixtures are mounted to are flat and free from defect. This is especially important

when installing product ranges that have been designed for correctional and health facilities, where special

attention is required to minimise ligature points and areas for concealment of contraband. In addition to ensuring

the products are fitted securely and in accordance with the following instructions, consideration shall be given to

the use of non-pick mastics such as BASF Sonolastic "Ultra" to ensure a high quality and safe installation.

MOUNTING DETAILS

NOM

115

NOM

1/2" CU/BSP

Version 2, 13 June 2017, Page 2 of 4

DRILL

33mm

NOM

115

NOM

1/2" CU /BSP

Multi-Grip