AGS Merlin 1000S 사용자 및 설치 매뉴얼 - 페이지 3
{카테고리_이름} AGS Merlin 1000S에 대한 사용자 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin 1000S 10 페이지. Gas utility isolation controller
AGS Merlin 1000S에 대해서도 마찬가지입니다: 설치, 운영 및 유지보수 매뉴얼 (10 페이지), 설치 및 운영 매뉴얼 (12 페이지), 설치 및 운영 매뉴얼 (16 페이지)
페이지 인쇄
Merlin 1000S
Gas Utility Controller
2
INSTALLATION & CONNECTION
(1)
[POWER L N E]
Mains Power Supply
A 110-120VAC Single Phase electrical supply should be supplied to the panel.
This should be externally fused at 3 Amps using a fused or circuit breaker.
(2)
[GAS VALVE L N E]
Gas Solenoid Valve Power Output
This outlet provides a 110-120VAC 3 amp signal to the solenoid valve. Please consult the
solenoid valve installation instructions for further information.
(3)
[BMS OUT]
Building Management System Connections
Terminal connections are available on the circuit board for connections to Building
Management systems. [NC – Normally Closed] [COM - Common] [NO – Normally Open].
These are volt free dry contact connections.
This is a relay that changes state in alarm or when gas is on/off and can be used in
conjunction with the 12VDC output and other external relays that affect other devices and
controls such as purge fans, audible alarms etc.
Rev: 04 Date: 15-08-18
User & Installation Manual
3