Galvin Engineering GalvinCare CP-BS 제품 설치 매뉴얼 - 페이지 4
{카테고리_이름} Galvin Engineering GalvinCare CP-BS에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering GalvinCare CP-BS 4 페이지. Lead safe mental health anti-ligature ceiling mounted shower rose stainless steel plate
Product Installation Guidelines
TROUBLESHOOTING
PROBLEM
Wall shower is dripping water
Wall shower has inconsistent
flow
Leak from behind body
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
CAUSE
Head-works are worn or
damaged
Blocked flow restrictor
Insufficient sealant
Version 1, 17 November 2022, Page 4 of 4
RECTIFICATION
Version 1, 17 November 2022, Page 4 of 4
Remove and inspect the head-works,
remove debris and replace head parts if
damaged
Remove flow regulator from the body
and remove debris. Install an inline
strainer to stop further blockages.
Apply more sealant