Galvin Specialised Ezy-Drink TD00L-LM 제품 설치 매뉴얼 - 페이지 3
{카테고리_이름} Galvin Specialised Ezy-Drink TD00L-LM에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised Ezy-Drink TD00L-LM 4 페이지. Lever action bubbler tapware
페이지 인쇄INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions
and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or
electrical supply conditions must also comply to the applicable national and/or state standards. Failing to
comply with these provisions shall void the product warranty and may affect the performance of the product.
1. Fit tap assembly
Fit the outlet into the bench.
Ensure the rubber sealing washer is
placed underneath the outlet body and
the anti-rotation pin locates properly.
Secure underneath with the supplied cup
washer and back nut.
2. Flow adjust
To adjust water flow
1. Remove the blanking screw
2. Adjust the water height by turning the
regulator screw
3. Replace blanking screw
Note: The full range from minimum flow to maximum
flow is only ¼ turn
3. Testing
Once the drinking tap has been installed and tested for leaks,
the water height must be adjusted to suit the available
pressure.
Version 2, 31 July 2017, Page 3 of 4