AFL IDEAA 144F 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} AFL IDEAA 144F에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFL IDEAA 144F 14 페이지.

3. Remove the top plate.

4. Determine the appropriate compression fitting

for the application.

5. Knock out the appropriate mounting hole

to accommodate the compression fitting.

6. Install the appropriate compression fitting.

Reference the Compression Fitting Installation

section of this document.

7. Using local engineering practices, determine the

port to be used on the MPO field for the MPO

distribution cable.

8. Use local accepted practices to clean the connector

end face and plug the connector into the appropriate

port. (Figure 11)

9. Use the fiber management rings to route the

MPO distribution cable through the back side of the

144F IDC. (Figure 12)

Note: A FUSEConnect

may be spliced onto a non-connectorized

distribution cable. The FUSEConnect

Splice-On Connector application will utilize the

same cable installation and routing techniques

outlined in steps 1-7. Reference the installation

instructions provided with the FUSEConnect

MPO Splice-On Connector. The document will

include the following:

•Fiber Preparation

•Fiber Splicing

•Connector Assembly

10. Use local accepted practices to label the MPO

distribution fiber connection in the appropriate space

on the door label, as applicable.

11. Repeat Steps 7 – 10 for each MPO distribution cable

to be installed.

MPO Splice-On Connector

MPO

INSTALLATION INSTRUCTIONS

IDEAA

Interior Distribution Cabinet

Figure 11

Distribution

Drop

Figure 12

Specifications are subject to change without notice.