AgSense AQUA-TRAC Lite 배선 지침 - 페이지 15

{카테고리_이름} AgSense AQUA-TRAC Lite에 대한 배선 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AgSense AQUA-TRAC Lite 20 페이지. 2015-18 soil moisture monitoring

Wiring the Acclima TDR315L Sensor

to the Aqua Trac Unit

Find the group of terminals (3) with the group label SDI.

1. Connect the Blue wire from the Probe to the terminal marked SDI as shown above.

2. Connect the White wire from the Probe to the terminal marked GND as shown above.

3. Connect the Red wire from the Probe to the terminal marked PWR as shown above.

4. Make sure the Sensor Power jumper on the board is set to 12v.

5. If multiple sensors are used, they must be pre-addressed starting at address 0,1,2,3 (max

of 4 sensors)

Page 12