Mainsboost Charger MBC 250SV 설치, 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Mainsboost Charger MBC 250SV에 대한 설치, 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Mainsboost Charger MBC 250SV 20 페이지. Multi water performance system

페이지 인쇄

2 IMPORTANT FACTS

A. Commissioning

2.11 Ensure the pump is primed as described in the priming section before starting,

damage to the shaft seal will result otherwise. See Section 8.16 -

Commissioning.

B. Water temperature

This unit is designed for cold water applications only which should not exceed the

following values:

2.12 The maximum allowable water temperature is 35

2.13 The minimum allowable water temperature is 4

C. Pipework - General

2.14 Secure pipework: Ensure pipework to and from the Mainsboost Charger is

independently supported & clipped to prevent forces being transferred to inlet

and outlet branches of pump. Flexible hoses supplied must be used.

2.15 Flux: Solder joints must be completed and flux residues removed prior to pump

installation (flux damage will void any warranty).

2.16 Pipework design: Care should be taken in the design of pipework runs to

minimize the risk of air locks e.g. use drawn bends rather than 90

D. Plumbing Installation Regulations

2.17 The plumbing installation must comply with the current water and building

regulations.

2.18 The plumbing installation must be installed by a qualified person.

2.19 The electrical installation must be carried out in accordance with the current

national electrical regulations.

2.20 The electrical installation must be installed by a qualified person.

READ BEFORE COMMENCING INSTALLATION

- 6 -

bends.

Cont ...