AireSpa ASWRB300 사용 및 관리 매뉴얼 - 페이지 16
{카테고리_이름} AireSpa ASWRB300에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AireSpa ASWRB300 20 페이지.
페이지 인쇄
Water tank empty
1.
Refill tank using pitcher.
2.
The three black dots in triangle form on the back wall of the large water tank are
water sensors. These sensors need to stay clean and free from debris. If sensors
are dirty, they may falsely trigger a WATER TANK EMPTY error.
3.
Use ordinary tap water. If you wish to use purified water, mix half tap and half
purified.
4.
Check the dam on the upper small reservoir.
Note: The dam may be loose allowing water to leak down into the large
water tank below. If the dam is loose and not holding the water in the small
tank, tightly push down to make sure the dam is closed.
5.
Check the white round tube in the top left corner of the small reservoir
(There is a white piece that looks like a tower. On the bottom of that tower there
is a round tube like ring. That ring floats when there is water in the small reservoir.
The ring may be stuck or jammed from particles which inhibits the ring from
floating. If this ring does not float, it does not trigger the humidifier to work.
Energy saver mode
•
The AireSpa purifier has a 24 hour energy saver mode.
•
Once the 24 hour cycle is complete, the unit will automatically shut off.
•
You can always reset the timer by long pressing the All Off Button.
[See: Page 4, Diagram #5]
To order more supplies please go to:
HELPFUL HINTS
Please Close the Front Panel
AireSpa.com
15