AGT INDUSTRIAL SSRPB80 제품 설명서 - 페이지 9

{카테고리_이름} AGT INDUSTRIAL SSRPB80에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGT INDUSTRIAL SSRPB80 18 페이지. Skid steer rock picker bucket

https://www.agrotkindustrial.com/

Installation

Unpack and check

Check for missing or damaged components according to the packing list.

If you have any questions, please contact the supplier. List of details

As the table above:

Machine installation

Equipment must be installed on a solid concrete floor or similar. If the ground is not firm, it will

not be able to connect to the loader. There should be a space around the device for easy

operation.

Connecting Brush Cutter

Connecting Rock Bucket Consult your skid steer operator's manual for specific instructions on

how to connect to your rock bucket loader.

General Attachment Method

1. Make sure the hydraulic lines are clear from the front side of the rock bucket attachment

plate and that the locking pins on the skid steer mounting plate are retracted.

2. Drive forward and place top of skid steer mounting plate under the attachment mounting

flange. See Figure below.

3. 3. Slowly raise and tilt back the skid steer mounting plate untilthe brush cutter attachment

plate rests flat against the skid steer mounting plate.

4. Activate your skid steer's lever lock switch to engage and lock the pins into the flange slots

of the brush cutter's attachment plate. If your skid steer does not have this switch, push the

latch handles down until you can see the lock pins extend into the attachment flange.

5. Connect the attachment hydraulic hoses and the case drain hose (SBCNS model only) to

the auxiliary supply couplers located on your skid steer loader lift arm.

Skid Steer Mounting Plate to Attachment Mounting Flange