Maiwe MIGE2205G Series 사용자 설명서 - 페이지 16

{카테고리_이름} Maiwe MIGE2205G Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Maiwe MIGE2205G Series 20 페이지. Industrial gigabit media converter industrial ethernet switch

페이지 인쇄

MIGE1203 Series Industrial Gigabit Media Converter/MIGE2205G Series

Industrial Ethernet Switch

Check the optical fiber terminator if it is clean. Slightly moisten a clean

paper towel or cotton ball, and gently wipe the cable plug. Dirty optical fiber

terminator will reduce the quality of optical transmission and affect port

performance

Connect one end of the optical cable to the optical interface, and the

other end to the optical interface of another device

After connection is completed, check the corresponding LINK/ACT

indicator of the optical port on the front panel. If the indicator is on, the

connection is valid.

3.3.3. Laying out cables

The cable layout must meet the following conditions:

Before laying out the cables, check whether the specifications, models

and quantities of all cables are in compliance with the construction drawing

design and contract requirements

Before laying the cable, check whether the cable is damaged, whether

there is a factory record and quality assurance certificate to prove its quality.

The specifications, quantity, routing direction, and location of the cables

to be laid should meet the design requirements of the construction drawings.

The length of each cable should be determined according to the actual

location.

Separate user cables and power cords

No broken wires or joints in the middle of the laid cables

Cables should be laid out neatly in the walkway, with even and smooth

Straight in the slot and not go beyond and block other cable inlet and

outlet holes. Tied and fixed at the cable exit or the cable bend.

Cables, power cords, and ground wires are placed in the same slot, no

overlap or mixed. If the cable is too long, please neatly placed in the middle of

the cable rack, and cannot be pressed on other cables.

Be careful knotting when laying pigtails and minimize the turning points

and the turning radius should not be too small. The lashing should be

moderately tight and not too tight. When laying on the cable rack, it should be

placed separately from other cables

Both ends of the cable should have corresponding marks, and the

content of the marks is concise and easy to maintain

Notice

Be careful knotting when laying pigtails and minimize the turning points

and the turning radius should not be too small to avoid serious loss of

optical signals and quality of communication.

- 12 -

link