AirFiciency CF60E 매뉴얼 - 페이지 2

{카테고리_이름} AirFiciency CF60E에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirFiciency CF60E 4 페이지. Heavy duty industrial ceiling fan

페이지 인쇄

National Electrical Code, ANSI/NFPA 70 - 1999 and local codes.

Lock in open position and tag it to prevent unexpected power application.

Check that power source conforms to electrical requirements of fan.

All electrical hookups should be made by a qualified person.

Figure 1

Make sure electrical power is shut off.

The ceiling outlet box MUST be metal and

anchored securely enough to support a

minimum of 80 lbs.

Loosen the 2 fixture mounting screws as

shown in Figure 1.

Slide mounting plate onto the ceiling outlet

box and secure by tightening the 2 fixture

mounting screws.

Check to make sure that the mounting plate

is level. If it is not level use washers (not

provided) secured with mounting screws

between ceiling outlet box and mounting

plate. Failure to level the mounting plate will

cause your installed fan to wobble, creating

noise and strain on the fan, and reducing the

motor life.

Once mounting plate is properly installed,

direct the electrical wires down so they are

accessible.

Figure 2

Lift fan body (without blades) up to mounting

plate and hook the metal safety cable securely

over the hook on the mounting plate as shown

in Figure 2.

Connect the electrical wires. All electrical

connections should be done by a certified

electrician.

Electrical Hookup

The installation shall be in accordance with the

Disconnect power at main service panel.

Mounting

Figure 1

Metal ceiling

outlet box

Mounting

mounting

Figure 2

Hook

Safety cable

plate

Fixture

screws

Ground and

ground wire

Electrical

connections

secured with

plastic wire

connectors by

certified

electrician