IKEA 304.972.73 매뉴얼 - 페이지 10

{카테고리_이름} IKEA 304.972.73에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA 304.972.73 40 페이지.

페이지 인쇄

ENGLISH

What to do if ...

Problem

The control panel is switched off, the

appliance does not work.

The internal light does not work.

The temperature inside the

compartments is not cold enough.

There is water on the bottom of the

refrigerator compartment.

The red

icon is flashing and a sound

signal is activated

The red

icon will light up, a sound

signal is activated and the letter "F" is

flashing on the display.

Before contacting the After-Sales Service:

Restart the appliance to see if the fault has been remedied. If it

persists, switch the appliance off again and repeat the operation

after an hour.

If your appliance still does not work properly after carrying out

the checks listed in the troubleshooting guide and switching

the appliance on again, contact the After-sales Service, clearly

explaining the problem and specifying:

• the nature of the problem

• the model

Possible causes:

The appliance may be in On/Stand-by

mode.

There may be an appliance power supply

problem.

The light may need replacing.

The appliance may be in On/Stand-by

mode

There could be various causes (see

"Solutions")

The defrost water drain is obstructed.

Door open alarm

It is activated when the door remains

open for a prolonged period of time.

Malfunction alarm

The alarm indicates the malfunction of a

technical component.

Note:

Gurgling, hissing and humming noises from the refrigerating system are

normal.

• the type and serial number of the appliance (given on the

rating plate)

• the Service number (the number after the word SERVICE on the

rating plate inside the appliance).

Note: if the direction of door opening is reversed, this operation

is not covered by the warranty.

Solutions:

Turn the appliance on pressing the On/

Stand-by button. Check that:

- there is not a power outage

- the plug is properly inserted in the

power socket and the mains double-

pole switch (if present) is in the correct

position (i.e. allows the appliance to be

powered)

- the household electrical system

protection devices are efficient

- the power cable is not broken.

- Models with LED lights: contact the

authorised Technical Assistance Service.

- Turn the appliance on pressing the On/

Stand-by button

Check that:

- the door close properly

- the appliance is not installed near a heat

source

- the set temperature is adequate

- the circulation of air through the

ventilation grilles on the base of the

appliance is not obstructed.

Clean the defrosting water drain (see

section "Maintaining and cleaning the

appliance")

To turn the sound signal off, close the

door of the product.

Call the authorized Technical Assistance

Service. To turn the sound signal off,

briefly press the "Turn off sound alarm"

button