decorflame M902L-42FDC 매뉴얼 - 페이지 6

{카테고리_이름} decorflame M902L-42FDC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. decorflame M902L-42FDC 8 페이지. Electric fireplace heater

FirEPlAcE iNSErt iNStAllAtiON

The fireplace insert can be installed after the mantel has been fully assembled.

wARNING: MAkE SURE THE FIREPLACE INSERT CONTROLS ARE IN THE OFF

POSITION AND THE UNIT IS NOT PLUGGED IN.

wARNING: DO NOT TOUCH. HOT SURFACE AT CENTER OF GRILL. HOLD LEFT OR

RIGHT SIDE OF THE GRILL wHEN PULLING OUT.

Step 1: Carefully place the insert in the unit opening. The front of insert should be flush

with the front of the mantel. Carefully lift the insert into the mantel until the top stopper

is against the mantel.

Step 2: Attach 3 short KD screws (U) at the top of insert and attach the L-mounting

bracket to base panel with 2 Short KD screws. See Fig S.

Step 3: Move assembled unit to desired location. Unit should not be positioned in area

exposed to direct sunlight.

After reading instructions completely, confirm all controls on fireplace are in the OFF

position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you

may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace

insert has been properly connected to a grounded electrical outlet, it is ready to

operate.

BACk

Fig. S

OPErAtiON BY tHE cONtrOl PANEl

The controls are located behind the grill below the front glass and can be accessed by

pulling the grill from the top, forward and down.

wARNING: DO NOT TOUCH. HOT SURFACE AT CENTRE OF GRILL. HANDLE LEFT

OR RIGHT SIDE OF GRILL wHEN PULLING OUT.

O/I: Press this button for main power and flame effect. The indicator light will turn on.

See below for other control switches.

1250w: For heat function - Press this switch while the O/I switch is in the ON position.

The indicator light will turn on.

Temperature Control: To adjust the temperature to your individual requirements, turn

the temperature control dial to the right (clockwise) to increase the desired temperature

and to the left for lower temperature. This temperature control dial can only be used

while the O/I switch and 1250W switch are in the ON position.

NOTE: When the O/I switch is turned off, the heater functions will stop even though the

switches may be in the ON position.

wARNING: DISCONNECT POwER AND UNPLUG THE POwER CORD BEFORE

ATTEMPTING ANy MAINTENANCE OR CLEANING TO REDUCE THE RISk OF FIRE,

ELECTRIC SHOCk OR DAMAGE TO PERSONS.

The bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning

off the unit and removing the light bulbs to avoid the accidental burning of the skin.

RISk OF FIRE: DO NOT ExCEED THE RECOMMENDED BULB wATTAGE.