Airgap TAP-A-FLOW AG250-203 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Airgap TAP-A-FLOW AG250-203에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airgap TAP-A-FLOW AG250-203 2 페이지. Kitchen /bathroom pedal stainless steel finish

페이지 인쇄

1 – Pedal mount

1 – Pedal plate

1 – Top mounting plate

6 – 4-40 pedal plate mounting screws

2 – #10x3/4 " length mounting screws

2 – #10x1" length mounting screws

1 –Screwdriver

The AG250-203, in combination with

AG250-002 valve, provides hands-free

faucet operation. Valve is ordered

separately.

Please read the instructions once through before starting.

PEDAL INSTALLATION INSTRUCTIONS

Apply top mounting plate at

the edge of the cabinet and

mark position of mounting

screws.Drill two holes for #10

screws. (13/64"). (FIG.1 )

Measure 1" from the bottom

of cabinet aligned with top

mounting plate, drill 1" hole

under the cabinet plate.

(FIG.1 )

Pass cable from the AG250-002 valve through the 1"

opening under the cabinet plate and connect it to the

pedal AG250-103.

Unscrew the front nut (1) on the valve cable and insert

the cable (4) through the slot on the back side of support

bracket AG250-203 pedal. The rear nut (3) remains at the

end of the thread (2). Adjust cable holder (2) for proper

pedal operation and secure its position with nuts (1) and

(3). Control cable (4) should be snug. (FIG. 2)

AG250-203

Installation Procedures

LIST OF PARTS ENCLOSED

Openings for

#10 screws

1" Diameter

FIG. 1

FIG. 2

-OVER-

Cold/Hot Potable Water

Verify that valve actuating cable is inside the

valve receptacle( FIG.3)

FIG. 3

Insert valve cable end T-bar (5) into the pedal

lever (6) (FIG. 2)

Connect pedal plate to the pedal mount using

six provided 4-40 screws (7). (FIG. 4)

FIG. 4

AG250-002

Mechanical Valve