Makita 6017D 사용 설명서 - 페이지 8
{카테고리_이름} Makita 6017D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6017D 13 페이지. Makita cordless driver drill instruction manual 6017d, 6018d, 6019d
Makita 6017D에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)
페이지 인쇄
OPERATION
8
Screwdriving operation
For model 6017D/6018D
Place the point of the driver bit in the screw head and apply pressure to the
tool. Start the tool. Release the trigger just as the screw bottoms out. If the trig-
ger is not released, the screw may strip out the hole or the screw and/or bit
may be damaged.
For model 6019D
Place the point of the driver bit in the screw head and apply pressure to the
tool. Start the tool slowly and then increase the speed gradually. Release the
switch trigger as soon as the clutch cuts in.
CAUTION:
•
Make sure that the driver bit is inserted straight in the screw head, or the
screw and/or bit may be damaged.
NOTE:
•
When driving wood screws, predrill pilot holes to make driving easier and
to prevent splitting of the workpiece. See the chart.
Nominal diameter of wood screw
Drilling operation
002137
First, turn the adjusting ring so that the pointer points to the
(6019D). Then proceed as follows.
Drilling in wood
When drilling in wood, the best results are obtained with wood drills equipped
with a guide screw. The guide screw makes drilling easier by pulling the bit into
the workpiece.
Drilling in metal
To prevent the bit from slipping when starting a hole, make an indentation with
a center-punch and hammer at the point to be drilled. Place the point of the bit
in the indentation and start drilling.
Use a cutting lubricant when drilling metals. The exceptions are iron and brass
which should be drilled dry.
CAUTION:
•
Pressing excessively on the tool will not speed up the drilling. In fact, this
excessive pressure will only serve to damage the tip of your bit, decrease
the tool performance and shorten the service life of the tool.
•
There is a tremendous force exerted on the tool/bit at the time of hole
break through. Hold the tool firmly and exert care when the bit begins to
break through the workpiece.
•
A stuck bit can be removed simply by setting the reversing switch to
reverse rotation in order to back out. However, the tool may back out
abruptly if you do not hold it firmly.
•
Always secure small workpieces in a vise or similar hold-down device.
(mm)
3.1
3.5
3.8
4.5
4.8
5.1
Recommended size of pilot hole
(mm)
2.0 - 2.2
2.2 - 2.5
2.5 - 2.8
2.9 - 3.2
3.1 - 3.4
3.3 - 3.6
006419
marking