Alico Optima BR58 사용 설명서 - 페이지 4
{카테고리_이름} Alico Optima BR58에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alico Optima BR58 14 페이지. Wireless network equipment optima series
Alico Optima BR58에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)
페이지 인쇄WNE Wiring Diagram
The wireless network equipment is powered by a 48 VDC Power over Ethernet power supply/injector
module. The following steps should be accomplished to power the WNE:
1.
Install the WNE enclosure either on a pole or to a wall.
2.
Follow the instructions in the next section to assemble the Ethernet weatherproof cable feed
through assembly.
3.
Connect one end of a patch (straight through) CAT 5e Ethernet cable to the AP24/58 through
the Feed through assembly.
4.
Connect the other end of the CAT5e cable to the power and data port of the Power Over
Ethernet Module.
5.
Locate the LAN Switch in your wiring closet and connect a patch (straight through) CAT 5e
cable from the IN/DATA port of the Power over Ethernet module to a LAN Switch port.
6.
Last connect the 48VDC power supply to the Power Over Ethernet injector. Using the
supplied AC power cord connect the power supply to the AC. The unit operates on 110/240
VAC, 50/60 Hz.
Figure 1 Connection Diagram
4