Align-Pilates C8-Pro Reformer 조립 지침 및 사용자 설명서 - 페이지 4

{카테고리_이름} Align-Pilates C8-Pro Reformer에 대한 조립 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Align-Pilates C8-Pro Reformer 12 페이지.

5. Insert the Reformer Carriage & checking the side wheel adjustment

With the reformer back on the floor, firstly remove the 2 rubber carriage stoppers

from the end of the runners (Fig. 8). Carefully remove the carriage bed from its

packaging. Before inserting the carriage familiarise yourself with the side wheel set

up and adjustment system (Fig. 7). Now with one person holding each side of the

carriage bed, gently slide the carriage in to the runners (Fig. 5) with the springs

pointing towards the standing platform.

After attaching at least one spring, roll the carriage back and forward checking

that the carriage runs freely for the whole length of the runner. There should be no

squeaking or interference from the side wheels, if there is the side wheels need to

be moved inwards. Conversely there should not be excessive side to side move-

ment of the carriage in the runners or the wheels need to be moved out.

If you have leg extensions adjustment of the side wheels can be done from under

the machine, if you do not it is advised to remove the carriage to adjust the wheels.

To move the side wheels in (ie because they are causing the carriage to jam or, causing squeaking noises) unscrew bolt

B a few turns (Fig. 7) then loosen the two A bolts and push the wheel bracket in until it hits the stop screw B, then retighten

bolts A - now try the carriage again. If there is too much side to side movement of the carriage then the side wheels

need to be moved out. To do this loosen bolts A, then tighten bolt B by a few turns, which will push the wheel out, then

retighten bolts A and try the carriage again. We recommend small adjustments each time and after a few trials you

should get the carriage to run perfectly, with no interference from the side wheels & lttle side to side movement possible.

6. Runner stoppers

Having installed the carriage now screw the stoppers back in hand

tight. The stoppers prevent the carriage from hitting the rope risers and

are designed to allow for quick removal of the bed for cleaning &

maintenance, (Fig.7). Simply unscrew to get access and ensure you

re-screw them back in before use.

7. Offset Shoulder rests

Insert the shoulder rests into each of the shoulder rest receiving holes

on the carriage bed (Fig. 9). They can be locked in place by placing

the locking pin through the hole at the bottom of the chromed bar (Fig.

10). The locking pins are attached on a string to the underside of the

carriage as shown in Fig 10.

Please note the new design of shoulder rests have one side offset, this means you have a choice of a

narrower or, wider position for the shoulder rests, according to how you insert them. See Fig. 11 & 12.

Fig.9

Fig.11

Fig. 7

End Stopper

Fig.8

Fig.10

Fig.12