Align-Pilates Half Cadillac 조립 지침 및 사용자 설명서 - 페이지 2

{카테고리_이름} Align-Pilates Half Cadillac에 대한 조립 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Align-Pilates Half Cadillac 8 페이지. For a, c & m series

COMPATIBILITY

This Half Cadillac is compatible with all A2 & A8 series reformers, which includes the A2, A2R and A2RII, A8-

Pro and C Series reformers from the C1-Pro, including the C2-Pro, C2-Pro RC & C8-Pro reformers and finally

the M2 & M8 reformers. The Half Cadillac can be attached to the listed reformers with any of the available

leg heights. In order to attach the Half Cadillac the correct bracket must be purchased separately. For

the A series reformers the part code for the correct bracket is PAPA2HALFCADBKT. For the C series the part

code is PAPC1PROHCADBKT. This manual assumes the correct bracket has been purchased prior to as-

sembly.

IMPORTANT NOTES BEFORE ASSEMBLY:

To assemble the Half Cadillac on reformers with 40 or 64cm legs you will need 2.45m or 2.75m high

ceilings respectively in order to insert the frame. It is therefore sensible to measure the ceiling height in

advance. In cases where the ceiling is high enough to accommodate the Half Cadillac but not to insert it,

the A2 series of reformers allows you to remove the reformer legs, then attach the Half Cadillac and finally

reattach the legs to avoid the ceiling height problem - see your reformer manual for information on

attaching the reformer legs.

Assembled Heights:

A series:Rehab Leg 235cm, Std Leg 213cm and Low Leg 199cm.

C Series: 195cm, C Series with leg extension 208cm,

M Series:213cm

At least two people are required to unpack & assemble the Half Cadillac. At all times you are responsible

for your own safety. Please unpack the equipment in a clear, clean & dry environment on a level floor

surface. Remove all strapping using a safety knife and remove the carton lid and remove the contents

from the boxes.

Half Cadillac Map:

Swing though bar

height adjustment

knob

Swing Through Bar

Sliding Spring eyelet

Safety strap

Roll down bar

47cm short springs

Hand Handles

64cm long springs

Double Loop Handles