Alinco DR-135 딜러 매뉴얼 - 페이지 8

{카테고리_이름} Alinco DR-135에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alinco DR-135 20 페이지. Vhf fm mobile transceiver

3. DR-135 Channel Data Editor

The DR-135 Channel Data Editor is used to edit data, which includes the

operation parameters for the transceiver and the settings for each channel.

This software is useful when you wish to program two or more transceivers in

similar ways;

You can read the existing data from a master transceiver, edit the parameters

on the editor, and enter the changes in other transceivers.

The DR135 Data Editor floppy disk provided by Alinco includes data editor

system files, DR135.EXE and DR135.HLP. To install the editor, the following

items are required in addition to this floppy disk:

• An IBM PC/AT or compatible computer is required.

• PC-DOS or MS-DOS 6.2 or later version is recommended.

• The Alinco ERW-4 or ERW-4C interface cable. This cable is specially

designed to connect the computer to the transceiver. Do not use it for other

purposes.

Note:

To instalI the editor:

Make an new directory for the data editor system, if needed.

Copy the DR135.EXE and DR135.HLP files from the DR-135 Data Editor

disk to the appropriate directory.

The Data Editor can start the DR-135 editor.

Note:

To start the editor:

Start the DOS on your computer.

Go to the directory where the Data Editor is located.

• If you run the editor with TSR software that runs off the CPU at regular

intervals, or from the DOS box of Windows, or with a device driver that

inhibits interruption for a long period of time, an error may occur during

data transfer between the PC and radio.

• If you are going to write new data into the transceiver after editing,

connect the COM port (Dsub connector) on your PC to the DATA

terminal on the transceiver with the interface cable (ERW-4 or ERW-

4C) before turning the computer on.