Garmin 010-C0033-00 - MapSource BlueChart - Lake Ontario 사용자 설명서 - 페이지 9
{카테고리_이름} Garmin 010-C0033-00 - MapSource BlueChart - Lake Ontario에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin 010-C0033-00 - MapSource BlueChart - Lake Ontario 15 페이지. Software de mapeamento
Garmin 010-C0033-00 - MapSource BlueChart - Lake Ontario에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 소유자 매뉴얼 (2 페이지), 사용자 설명서 (30 페이지), 사용자 설명서 (28 페이지), (포르투갈어) 사용자 설명서 (30 페이지)
페이지 인쇄
Installation
Installing the Device Drivers
The required driver fi les which the USB Data Card
Programmer needs to fi nd on either the USB Data
Card Programmer CD, the City Navigator CD, or the
MapSource Setup CD are:
grmn0200.inf
grmn0200.sys
grmn1200.sys
If these fi les cannot be seen in the root directory on the
CD using Windows Explorer, your View settings may
need to be adjusted.
2
7. When installation is complete a window will display that shows
the device name (Garmin USB Data Card Programmer) and states
the driver installation is fi nished. Click on "Finish".
8. A fi nal window will appear telling you that operating software for
the Card Programmer is being installed.
9. To make sure the USB Programmer has been successfully installed:
From the Control Panel, click on "System", then the "Device
Manager" tab, then click the + by "Universal serial bus control-
ler". You should see "Garmin USB Data Card Programmer" on the
list. Another method would be to open the MapSource program,
click the 'Save To Device' icon, then the 'USB Port' tab. You should
see "Card Programmer" listed in the "Save Maps To:" window.
If you see a yellow '!' mark in front of the device name, (install)
appears at the end of the Programmer name or the Programmer
appears under "Other Devices" as an unknown device, follow these
alternate steps to install the Programmer:
1. Double-click the My Computer icon from your Desktop. For Win-
dows 98, click "View", "Folder Options", then the "View" tab.
For Windows 2000/ME, click "Tools", "Folder Options", then the
"View" tab.
2. Make note of the following changes if you wish to change your
View settings back after installing the Programmer. Change the
Hidden Files selection to "Show All Files" or "Show hidden fi les
and folders" and uncheck the "Hide fi le extensions for known
fi le types" or "Hide protected operating system fi les", then click
"OK".
3. Be sure the driver CD is inserted and the USB Programmer is
plugged into the PC. Open the Control Panel. For Windows 98,
click on "System", then the "Device Manager" tab. For Windows
2000/ME, click the "Hardware" tab, then click "Device Manager".