Garmin GDL 69A 사용 설명서 - 페이지 20
{카테고리_이름} Garmin GDL 69A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GDL 69A 44 페이지. Xm satellite radio instructions for continued airworthiness
Garmin GDL 69A에 대해서도 마찬가지입니다: 활성화 지침 (46 페이지), 파일럿 매뉴얼 부록 (50 페이지), 활성화 지침 (38 페이지), 파일럿 매뉴얼 부록 (50 페이지), 활성화 지침 (16 페이지), 사용 설명서 (8 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
5. Refer to Table 4-1 to read the SAT ID/CONNECTIVITY information.
6. Verify radio IDs and signal quality is between 2 – 3. If signal quality is zero, check the antenna and
wiring.
'- -'
'XM'
'X0', 'X1', 'X2', or 'X3'
'-0', '-1', '-2', or '-3'
"Searching..."
"Satellite in view"
4.3 Verify SiriusXM Subscribed Services
The 430/530 supports the following weather services: NEXRAD, graphical METAR, text-based
METAR, Wind, and Graphical Temperature/Dew Point. These services are available only in the
United States. Verify included services by displaying them on the unit, if applicable. If signal quality is
between 1 and 3, but no data is displayed, contact SiriusXM Satellite Radio to verify subscription. Be
sure that the unit is updated with the most current software.
Page 14
GDL 69/69A XM Satellite Radio Activation Procedures
Figure 4-2. Data Link Status Page
Table 4-1. Data Link Status
SAT ID Field
GDL 69/69H – 430/530 Series interface communications not yet established.
GDL 69/69H not yet communicating with internal satellite radio hardware (normal
during power-up).
'X' = Satellite radio service activated. Satellite signal quality is indicated by the
numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
'-' = Satellite radio service is not activated. Satellite signal quality is indicated by
the numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
Connectivity Field
No satellite is currently in view, signal quality is '0'.
Indicates a signal quality between 1 and 3.
190-00355-04
Rev. K