AlkaViva The ionpia H2 소유자 매뉴얼 - 페이지 9

{카테고리_이름} AlkaViva The ionpia H2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AlkaViva The ionpia H2 13 페이지.

Installing Digital Flow Meter

1. Slide open the battery case cover and put in 2 AAA batteries. Replace the cover.

2. Make sure the water is SHUT OFF. Decide where in your white ¼" tubing you would like to

place the DigiFlow Meter. Using a sharp knife or sharp pair of kitchen scissors, make a straight cut

through the tubing.

3. Push the inlet tubing into the quick connect fittings on each side. Push until they are fully

seated, then give a light pull to be sure that they are seated properly.

Operating the Digital Flow Meter

The DigiFlow 8800T will automatically turn on when water is flowing through and show remaining

filter life capacity. It will automatically shut off 10 seconds after the water flow stops. When no

water is being ran through it you can view the remaining filter life by pressing CHECK/RESET

button.

*The DigiFlow meter counts down, meaning it will show you how many gallons are left, not how

many have been used.

When the meter reaches zero(0), indicating your filters have expired, the DigiFlow meter will start

making a series of short beeping noises and blink zero(0) to notify you that it is time to replace

your filters. To reset the meter press and hold the CHECK/RESET button for 5 seconds until the

capacity is reset to 700 gallons. When the battery gets low the meter will beep as though the

filter is expired, however it will not show zero(0) and a picture of a battery will show in the corner

of the screen.

Page 9

HYDROGEN GENERATOR