Garmin GTX GTX 330D 파일럿 매뉴얼 - 페이지 9

{카테고리_이름} Garmin GTX GTX 330D에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX GTX 330D 13 페이지. Mode s transponder
Garmin GTX GTX 330D에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 (13 페이지), 설치 매뉴얼 (49 페이지)

페이지 인쇄

Mode S Data Transmission

In addition to 4096 code and pressure altitude, the GTX 330 is capable of transmitting

aircraft identification, transponder capability, and maximum speed range. Aircraft

identification is commonly referred to as FLT ID (Flight Identification). The GTX 330 may be

configured by the installer to allow the flight crew to enter FLT ID for each flight. An example

is when air-carrier service requires changing the FLT ID.

The FLT ID may consist of the aircraft registration or a flight number as agreed upon with

the local aviation authority. In either case, the FLT ID must be the same aircraft identification

that appears in the flight plan to correlate the aircraft identification seen on ATC radar with the

correct voice call sign for the aircraft. If no flight plan is filed with the aviation authority (as

may be permitted by regulations), the FLT ID entered is the aircraft registration marking.

When flight crew entry of the FLT ID is not required, the installer configures the system to

report the aircraft identification according to local aviation requirements. In this configuration,

alteration of the FLT ID by the flight crew is not possible.

Flight ID Entry Dialog

When ALLOW PILOT TO EDIT FLT ID is enabled at installation, the flight crew may

change the Flight ID after power up by navigating to the FLIGHT ID Page and pressing the

CRSR key. This opens the Flight ID Entry dialog. After the flight crew enters the correct

Flight ID, the aircraft identification that is transmitted in response to ATC radar interrogations

will properly correlate with the associated call sign for voice communication with the aircraft.

If ALLOW PILOT TO EDIT FLT ID is required but is disabled, contact a Garmin

authorized service center for GTX 330 configuration.

Editing the Flight ID

When the Flight ID Entry dialog is displayed, press the CRSR key to begin editing the

Flight ID. To change a character, press the number keys corresponding to the alphanumeric

character entry. For example, to enter the letter R, press the 5 key four times. Each time an

alphanumeric character is entered, press the CRSR key to move the cursor to the next blank

field. Pressing the CLR key moves the cursor back to the previous character. Once the last

character is entered, press the CRSR key to move the cursor over the remaining blank fields to

complete Flight ID entry.

NOTE: No space is needed when entering Flight ID characters. When a

flight ID contains a space, the GTX 330 automatically removes the spaces

upon completion of Flight ID entry.

Flight ID Entry Dialog

Editing the Flight ID