Garmin Colorado 400c 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Garmin Colorado 400c에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Colorado 400c 40 페이지. Oregon series
Garmin Colorado 400c에 대해서도 마찬가지입니다: 소유자 매뉴얼 (48 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 소유자 매뉴얼 (48 페이지), 중요 안전 정보 (48 페이지), 소유자 매뉴얼 (26 페이지), (덴마크어) 매뉴얼 (48 페이지)

To mount the bracket assembly:

1. Using the swivel base as a template, mark the location of the

three holes that secure the bracket to the mounting surface.

2. Drill the mounting holes.

• If you secure the base with machine bolts, drill three

5/32" (5 mm) holes at the locations you marked.

• If you secure the base with self-tapping screws, drill

starter holes at the locations you marked. Do not make

the starter holes deeper than half the screw length.

3. Secure the swivel base with three bolts or screws. DO NOT

OVERTIGHTEN.

4. Place the swivel mount bracket over the swivel base and

secure it with the short knob.

Fishfinder 400C Owner's Manual

Installing the Fishfinder 400C on the Mounting Bracket

To install the unit on the mounting bracket:

1. Align the slot on the back of the fishfinder with the long

mounting knob, and slide the fishfinder into place. If

necessary, adjust the long knob to spread the bracket arms

apart. (Turn counter-clockwise to widen the bracket arms and

clockwise to tighten.)

2. Adjust the fishfinder angle, and tighten the long mounting

knob until snug.

3. Rotate the swivel mount bracket by twisting it left or right.

The bracket clicks as you turn it. Select a good viewing

angle, and then tighten all knobs.

4. Connect the power/data and transducer cables to the back

of the fishfinder, making sure the locking rings are fully

tightened on both connectors.

400c

nstallIng the

IshFInder