AEG F45078I-M 사용자 설명서 - 페이지 10

{카테고리_이름} AEG F45078I-M에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG F45078I-M 19 페이지. 18” fully integrated dish washer
AEG F45078I-M에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 일반 매뉴얼 (43 페이지)

페이지 인쇄
AEG F45078I-M 사용자 설명서
EN
Only run a soak program with half loads.
After using the above table to choose the most suitable washing cycle, program
the appliance.
2.2.1

Switching on

Press on/off (ref. 1 fi g. 2-02) to start the dishwasher; the indicator lights show the
"status" of the dishwasher.
2.2.2

Selecting and starting the program

•
Press the program
cator light corresponding to the required program turns on (ref. 4 fi g. 2-02);
•
if necessary, press the relative buttons to select the complementary functions
you wish to use (e.g. "Programming delay");
•
to start the dishwasher, press the
seconds until the indicator light of the selected program starts fl ashing (con-
fi rmation beep);
•
Program status is indicated by the indicator light fl ashing throughout the
cycle.
10
Before starting a washing program, make sure that:
•
The water supply tap is
•
There is regenerating salt
see the instructions in the general manual).
•
The correct amount of detergent
er (to add detergent, see the instructions in the general manual).
•
The spray arms are able to rotate
•
The racks have been
general manual).
•
The dishwasher door
Programming operations can only be performed with the door closed.
With the door open, the program indicator lights (ref. 4 fi g. 2-02) remain
off .
selection button (ref. 3 fi g. 2-02) several times until the indi-
If the door of the dishwasher has not been closed or has been incorrectly
closed, the washing cycle will not begin.
USER INSTRUCTIONS
open.
in the water softener tank (to add salt,
has been added to the dispens-
freely and without obstruction.
correctly loaded (see the instructions in the
is securely closed.
start/pause button (ref. 2 fi g. 2-02) for a few
Rev 0.0